MultiBrax® MultiGrinder attachment MB 650 MV

Article id: MB 650 MV

Groups: MultiBrax attachments


This unique MultiGrinder attachment changes a common, adjustable angle grinder into a belt file, a fillet weld grinder and a Roloc grinder.


as belt file

  • Application of common belt dimensions (Width: 6 - 15 mm, length: 520, 533, 610 and 650 mm)
  • The straight belt guide reduces the load on the belt closures
  • Due to the concave and cross-knurled drive wheel, a centric belt run is guaranteed
  • A wearing down of the grinding belt is nearly impossible due to the optimal spring tension.

as fillet weld grinder

  • This patented, low multifunctional roll (35 mm) allows working in angles, as e.g. at assembled hand rails
  • The slim design in combination with the small unitized compact discs (90 mm) allows working at hard-to-reach areas, as e.g. on fillet welds
  • The protective pipe over the driving beltprovides a higher occupational safety and a better handling.

as Roloc grinder

  • This patented, low multifunctional roll (35 mm) allows working with Roloc discs and also allows working in hard-to-reach areas.
  • Versatile application possible in tooling, mould construction, mechanical engineering, container, model, plane and engine construction
  • With adapter ZN 300 the direct inserting on the M 14 threaded spindle of the angle grinder is possible
  • Simple assembly, no tools required
  • High-quality, sturdy but light attachment
  • The protective pipe provides a higher occupational safety and a better handling
  • Contact arm and protection pipe are easily exchangeable due to the newly designed quick-change system
  • The slim design allows working in hard-to-reach areas
Any questions?
Our qualified staff will help you.
Contact now
GeBrax GmbH
Obere Hommeswiese 41-45
57258 Freudenberg
Tel.: +49 2734-28474-0
Fax : +49 2734-28474-10